Thanks for visiting Best Cordless Drill. Remember to bookmark this page Black Cordless Alligator.
 Black & Decker Proffesional Powerful Alligator Lopper 18-V Cordless Chain Saw US $105.77 
|
 Black & Decker 18V Cordless Alligator Lopper NLP1800 NEW US $96.98
|
 Black & Decker Cordless Alligator Lopper 6 Inch replacement saw Chain RC600 US $7.50
|
 Black & Decker Cordless 18V Chainsaw Loppers Alligator NLP1800 US $10.50
|
 BLACK & DECKER NLP1800 18V CORDLESS ALLIGATOR LOPPER 6" CUTTING BAR AUTH DEALER US $118.99
|
 Black & Decker NLP1800 Alligator Cordless Chainsaw NEW US $99.99
|
 Black & Decker Alligator Cordless Chainsaw Equipment US $116.65
|
 Black and Decker NLP1800 Alligator Lopper 18-Volt Cordless Chain Saw US $113.39
|
 BLACK & DECKER Alligator 6 in. Electric Cordless Chain Saw NLP1800 US $85.95
|
 BLACK & DECKER NLP1800 18V CORDLESS ALLIGATOR LOPPER 6" CUTTING BAR US $99.99
|
 Black & Decker Alligator Lopper 18-Volt Cordless Chain US $141.99
|
 Black & Decker NLP1800 Alligator Lopper 18-Volt Cordless Chain Saw Chainsaws New US $114.99
|
 Black & Decker Cordless Alligator Lopper NLP1800 US $127.38
|
 Black & Decker Alligator Lopper 18 Volt Cordless Chain Saw Battery Tree Cuttter US $104.95
|
 Black & Decker NLP1800 Alligator Lopper 18-Volt Cordless Chain Saw US $114.99
|
Black Cordless Alligator
Black & Decker NLP1800B 18 Volt Cordless Alligator Lopper Chain Saw - Bare Tool (No Battery Or Char
Fixing a Battery on a Drill
Note and mark the silver cardboard insulator where the wires go from the terminal, through the silver insulator and into the battery pack. Again, noting where these wires go will make the battery pack easier to assemble.
Use a voltmeter to check which leads on your cordless drill battery pack are positive and negative. Mark these as positive and negative to assist you in later reassembly.
Wrap the exposed metal band with electrical tape to insulate it during the battery-reconditioning process. This metal band will be hot during the reconditioning process, and wrapping it will protect you from injury.
Prepare for the reconditioning process by locating the positive and negative ends of the first cell. Prior to reconditioning this cell, prepare your 12-volt power source and put on safety glasses, insulated gloves and a long-sleeved shirt for protection.
Release the alligator clamps and use the battery tester to determine if the battery cell is fully charged. If not, repeat the zapping process. The cell can be zapped up to 10 times.
Access the batteries by cutting off a portion of the shrink wrap covering the batteries. You will need access to the tops and bottoms of the batteries. The cells within the shrink wrap are internally banded together. Leave these bands connected.
Open the battery case by removing the screws on the outside of the battery case
with a Phillips head screwdriver. Organize the screws and any springs or additional items that fall out of the case in a small container.
Test the cell again with the battery tester to verify that the cell has been repaired and will take a charge. If the cell still does not take a charge, repeat step 8 for a maximum of 10 times until the battery holds a charge. If the cell will not hold a charge after 10 attempts, it will have to be replaced entirely.
Choose one of the battery cells that you marked with tape in the previous step to be repaired. Locate the positive and negative ends of the cell, which can be identified by their flat or raised surfaces, respectively.
Remove the Dewalt battery pack from the Dewalt cordless tool. Use a small screwdriver to open the Dewalt battery case. Set the screws aside for later reassembly.
Prepare to "zap" the cell back to life using the 12-volt power source. Hold the black alligator clamp to the negative end of the battery while holding the red alligator clamp to the positive end of the battery. Hold this link for no longer than two seconds.
About the Author
If you are looking for a different item here are a list of related products on Best Cordless Drill, please check out the following:
Frequently Asked Questions...
black and decker 1000 cordless alligator lopper?
thinking of buying one. are they any good? got plenty of power?
Answer:
I tried one that a customer of mine had bought - not great; they have fairly hefty jaws and so are difficult to manoever and fit between congested limbs (which is why you might need them!). They are OK power-wise if you have a clear run of open-spaced limbs up to 1½" diameter - say, maybe reducing a laurel hedge by a couple of feet - a proper boys-toy! Buy a (Stihl) pruning saw and a pair of loppers - much more versatile! Good luck 